Show HN: We chased a weather balloon across Montana and never found it

·Hacker News··

Since April, I have been working with Sam Flynn (https://drook.dev) to make this balloon payload, UpLink. We did a similar launch last year with Hack Club but this was our first independent launch.UpLink was a 491 gram payload testing the insulation properties of 3D printing filaments, while also transmitting 320x240 images over a radio link -- up from the 18x10 images last year!This is a writeup on our engineering process, mistakes made, and learning experiences. It covers:- Custom electronics designed in KiCad- Firmware design- Results from the data we received on the ground- Image transmission- Launch day logistics, and where things went wrongAll hardware, software, firmware, and CAD is available on GitHub: https://github.com/radeeyate/UpLink, licensed + certified as open source hardware: https://certification.oshwa.org/us002826.htmlIf you just want to see the images received, I put up a gallery here: https://uplink.gallery.radi8.dev/If you have any questions, comments, or concerns, let me know. I'm happy to answer anything!

Read full article →

Related Articles

Unauthenticated remote code execution in Nginx
speedping · Hacker News · 1d ago
Cooling buildings is overtaking heating them as an energy need, IEA says
robtherobber · Hacker News · 8h ago
Ruby2ßhell: Pre-authentication RCE on stock Rails
jdns · Hacker News · 18h ago
Pancreatic cancer halted by virus injection in three patients
cybermango · Hacker News · 5h ago
Highly classified US national security communications network goes down
monkeydust · Hacker News · 2d ago